![]() Or press ctrl + N to clear canvas and draw a new base tool. How do you clear a canvas in Zbrush? Edit mode: (shortcut ‘T’). Turn on Rgb and set RGB Intensity to 100.Turn off Zadd or ZSub to avoid sculpting your model as you paint.Turn on Colorize in the Tool > Polypaint sub-palette.Make sure there are sufficient polygons to support the detail you want to paint.Holding Ctrl+Shift while clicking on a polygroup toggles the visibility of that polygroup. Then, go to Tool>Polygroups to access different polygrouping methods. How do I assign a Polygroup? To assign polygroups: Click on Make PolyMesh3D to make an active subtool a polygon mesh if not yet. ![]() Invert this selection: press CTRL+SHIFT then click and drag outside the model.Press CTRL+SHIFT and click on the other groups you want to select.Invert that selection: press CTRL+SHIFT then click and drag outside of the mesh.Press CTRL+SHIFT and click on the mesh where one group is.When clicking in any empty part of the document you will isolate the selected SubTool and temporarily hide all others. How do you isolate a SubTool in ZBrush? You can enable Solo mode’s single-click option by activating the Preferences > Edit > Click to Solo switch. Optionally, in the same panel, you may click Close Holes to cap open holes. ![]()
0 Comments
Leave a Reply. |